Effect of SiO2, Al2O3 and Na2O content and fly ash fineness on the structure and mechanical properties of fly ash based geopolymer

Roland Szabó; Gábor Mucsi

doi:10.5937/ror1901061S

Authors

Roland Szabó University of Miskolc, Institute of Raw Material Preparation and Environmental Processing, Miskolc, Hungary Author https://orcid.org/0000-0002-4536-7610
Gábor Mucsi University of Miskolc, Institute of Raw Material Preparation and Environmental Processing, Miskolc, Hungary Author https://orcid.org/0000-0003-1031-2801

DOI:

https://doi.org/10.5937/ror1901061S

Keywords:

fly ash, metakaolin, geopolymer, mechanical activation, SiO2/Al2O3 molar ratio, SiO2/Na2O molar ratio, Al2O3/Na2O molar ratio

Abstract

Nowadays, the geopolymer technologies using secondary raw materials are more and more widespread; however, some of them (for example fly ash) have originally low reactivity which can be tailored by a mechanical or chemical activation, or by the addition of various high reactive materials. This study investigates the effect of silica, alumina, and sodium oxide contents on the structure and mechanical properties of high calcium fly ash based geopolymers. Metakaolin (MK) was used as an additional alumina and silica source. It was added at various dosages (0; 5; 10; 15; 25; 50 and 75% by weight) as a replacement of the fly ash (FA). The experimental results confirm that the compressive strength of the geopolymer is greatly affected by the SiO2/Al2O3, Al2O3/Na2O, and SiO2/Na2O ratio. The addition of MK improved the compressive strength of geopolymer by 92%. In addition, the effect of mechanical activation of FA on the structure and strength of the geopolymer was investigated in case of a given MK content. Based on the results it can be stated that the mechanically activated FA resulted in higher compressive strength. The addition of MK and the fineness of FA changed the structure of geopolymers, which was detected using FT-IR spectroscopy method.

References

Bignozzi M. C., Manzi S., Natali M. E., Rickard W. D., Van Riessen A., Room temperature alkali activation of fly ash: the effect of Na2O/SiO2 ratio, Construction and Building Materials, 69, 2014, 262-270,

https://doi.org/10.1016/j.conbuildmat.2014.07.062

Chen X., Niua Z., Wanga J., Zhua G. R., Zhoua M., Effect of sodium polyacrylate on mechanical properties and microstructure of metakaolin-based geopolymer with different SiO2/Al2O3 ratio, Ceramics International, 44 (15), 2018, 18173-18180,

https://doi.org/10.1016/j.ceramint.2018.07.025

Cheng Y., Hongqiang M., Hongyu C., Jiaxin W., Jing S., Zonghui L., Mingkai Y., Preparation and characterization of coal gangue geopolymers, Construction and Building Materials, 187, 2018, 318-326,

https://doi.org/10.1016/j.conbuildmat.2018.07.220

Chindaprasirt P., De Silva P., Crentsil K. S., Hanjitsuwan S., Effect of SiO2 and Al2O3 on the setting and hardening of high calcium fly ash-based geopolymer systems, Material Science, 47 (12), 2012, 4876-4883,

https://doi.org/10.1007/s10853-012-6353-y

Criado M., Fernandez-Jiménez A., Palomo A., Alkali activation of fly ash: effect of the SiO2/Na2O ratio: Part I: FTIR study, Microporous and Mesoporous Materials, 106 (1-3), 2007, 180-191,

https://doi.org/10.1016/j.micromeso.2007.02.055

Davidovits J., Geopolymers and geopolymeric new materials, Journal of Thermal Analysis, 35 (2), 1989, 429-441,

https://doi.org/10.1007/BF01904446

Davidovits J., 30 years of successes and failures in geopolymer applications, Market trends and potential breakthroughs, Geopolymer 2002 Conference, Melbourne, Australia, October 2002, 1-16, https://www.geopolymer.org/fichiers_pdf/30YearsGEOP.pdf overtaken 05.05.2019.,

Fernandez-Jimenez A., Palomo A., Composition and microstructure of alkali activated fly ash binder: effect of the activator, Cement and Concrete Research, 35 (10), 2005, 1984-1992,

https://doi.org/10.1016/j.cemconres.2005.03.003

Gao K., Lin K. L., Wang D. Y., Hwang C. L., Shiu H. S., Chang Y. M., Cheng T. W., Effects SiO2/Na2O molar ratio on mechanical properties and the microstructure of nano-SiO2 metakaolin-based geopolymers, Construction and Building Materials, 53, 2014, 503-510,

https://doi.org/10.1016/j.conbuildmat.2013.12.003

Granizo M. L., Varela M. T. B., Palomo A., Influence of the starting kaolin on alkali-activated materials based on metakaolin, Study of the reaction parameters by isothermal conduction calorimetry, Journal of Materials Science, 35 (24), 2000, 6309-6315,

https://doi.org/10.1023/A:1026790924882

He P., Wang M., Fu S., Jia D., Yan S., Yuan J., Xu J., Wang P., Zhou Y., Effects of Si/Al ratio on the structure and properties of metakaolin based geopolymer, Ceramics International, 42 (13), 2016, 14416-14422,

https://doi.org/10.1016/j.ceramint.2016.06.033

Khedmati M., Alanazi H., Kim Y. R., Nsengiyumva G., Moussavi S., Effects of Na2O/SiO2 molar ratio on properties of aggregate-paste interphase in fly ash-based geopolymer mixtures through multiscale measurements, Construction and Building Materials, 191, 2018, 564-574,

https://doi.org/10.1016/j.conbuildmat.2018.10.024

Komintsas K., Zaharaki D., Geopolymerisation: A review and prospects for the mineral industry, Mineral Engineering, 20 (14), 2007, 1261-1277,

https://doi.org/10.1016/j.mineng.2007.07.011

Kumar S., Mucsi G., Kristály F., Pekker P., Mechanical activation of fly ash and its influence on micro and nano-structural behaviour of resulting geopolymers, Advanced Powder Technology, 28 (3), 2017, 805-813,

https://doi.org/10.1016/j.apt.2016.11.027

Molnár Z., Szabó R., Rácz Á., Lakatos J., Debreczeni Á., Mucsi G., Optimization of activator solution and heat treatment of ground lignite type fly ash geopolymers, IOP Conference Series: Materials Science and Engineering, 175, 2017, 1-8,

https://doi.org/10.1088/1757-899X/175/1/012046

Mucsi G., Lakatos J., Molnár Z., Szabó R., Development of geopolymer using industrial waste materials, The 9th International Conference Environmental Engineering, Vilnius, Lithuania, May 2014, 1-8, Editors: Cygas D. and Tollazzi T., Publisher: Vilnius Gediminas Technical University Press Technika, eISBN 978-609-457-640-9,

https://doi.org/10.3846/enviro.2014.039

Ozer I., Soyer-Uzun S., Relations between the structural characteristics and compressive strength in metakaolin based geopolymers with different molar Si/Al ratios, Ceramics International, 41 (8), 2015, 10192-10198,

https://doi.org/10.1016/j.ceramint.2015.04.125

Palomo A., Grutzeck M. W., Blanco M. T., Alkali activated fly ashes: A cement for the future, Cement and Concrete Research, 29 (8), 1999, 1323-1329,

https://doi.org/10.1016/S0008-8846(98)00243-9

Panias D., Giannopoulou I. P., Perraki T., Effect of synthesis parameters on the mechanical properties of fly ash-based geopolymers, Colloids and Surfaces A: Physicochemical and Engineering Aspects, 301 (1-3), 2007, 246-254,

https://doi.org/10.1016/j.colsurfa.2006.12.064

Silva P. D., Crenstil K. S., Medium-term phase stability of Na2O-Al2O3-SiO2-H2O geopolymer systems, Cement and Concrete Research, 38 (6), 2008, 870-876,

https://doi.org/10.1016/j.cemconres.2007.10.003

Singh S., Aswath M. U., Ranganath R. V., Effect of mechanical activation of red mud on the strength of geopolymer binder, Construction and Building Materials, 177, 2018, 91-101,

https://doi.org/10.1016/j.conbuildmat.2018.05.096

Swanepoel J. C., Strydom C. A., Utilization of fly ash in a geopolymeric material, Applied Geochemistry, 17 (8), 2002, 1143-1148,

https://doi.org/10.1016/S0883-2927(02)00005-7

Tchakoute H. K., Elimbi A., Kenne B. B. D., Mbey J. A., Njopwouo D., Synthesis of geopolymers from volcanic ash via the alkaline fusion method: Effect of Al2O3/Na2O molar ratio of soda-volcanic ash, Ceramics International, 39 (1), 2013, 269-276,

https://doi.org/10.1016/j.ceramint.2012.06.021

Tchakoute H. K., Rüscher C. H., Kamseu E., Andreola F., Leonelli C., Influence of the molar concentration of phosphoric acid solution on the properties of metakaolin-phosphate-based geopolymer cements, Applied Clay Science, 147, 2017, 184-194,

https://doi.org/10.1016/j.clay.2017.07.036

Vaou V., Panias D., Thermal insulating foamy geopolymers from perlite, Minerals Engineering, 23 (14), 2010, 1146-1151,

https://doi.org/10.1016/j.mineng.2010.07.015

Vargas A. S. D., Molin D. C. D., Vilela A. C., Da Silva F. J., Pavao B., Veit H., The effects of Na2O/SiO2 molar ratio, curing temperature and age on compressive strength, morphology and microstructure of alkali-activated fly ash-based geopolymers, Cement & Concrete Composites, 33 (6), 2011, 653-660,

https://doi.org/10.1016/j.cemconcomp.2011.03.006

Wallah S. E., Rangan B. V., Low-calcium fly ash-based geopolymer concrete: Long-term properties, Research report GC 2, Faculty of Engineering, Curtin University of Technology, Perth, Australia, 2006, https://www.geopolymer.org/fichiers_pdf/curtin_flyash_GC-2.pdf, overtaken 05.05.2019.,

Živica V., Balkovic S., Drabik M., Properties of metakaolin geopolymer hardened paste prepared by high-pressure compaction, Construction and Building Materials, 25 (5), 2011, 2206-2213.

https://doi.org/10.1016/j.conbuildmat.2010.11.004